Tigercat Harvester H845C, LH845C Operator’s Manual PDF

Note: You may also be interested in the following PDF manual for Tigercat Harvesters H845C, LH845C:
Service Manual

The PDF Operator's Manual will assist the operator with the techniques of proper and safe operation of the Tigercat Harvesters H845C, LH845C Models.

There is also important service information regarding the safe operation of the attachment. The pdf manual contains safety and servicing procedures and a preventive maintenance schedule to ensure optimum machine performance.

For the proper operation and routine maintenance of Tigercat Harvesters, you should familiarize yourself with all the sections of this manual in detail. We recommend that you pay special attention to the section on safety information.

If you follow all the recommendations and rules specified in this pdf instruction, then you can avoid a lot of breakdowns, injuries, or other problems. The manual interface is very simple and easy to use since it is a pdf file. So it does not require installation (INSTANT DOWNLOAD). To work with the PDF manual, we recommend that you use the Adobe Acrobat Reader application.

At the top of the page, you can see the link 'Tigercat pdf manual instant preview'. By clicking on it, you can see what this manual is all about, what quality of pictures and drawings in it. You can also read the list of content that is presented below.

If you have any questions or problems with downloading the file, you can write to us and we will help you.

Serial Numbers:
H845C 84531861 TO 84532500
LH845C 84581861 TO 84582500

84531501 TO 84531860
84581501 TO 84581860

Models covered:
H845C,
LH845C.

CONTENTS:

• INTRODUCTION
• STANDARDS TOPS, FOPS, OPS
• NON-APPROVED FIELD PRODUCT CHANGES
• SECTION 1 - SAFETY
  • BATTERY SAFETY
  • CAB EXITS
  • COOLING SYSTEM
  • EC DECLARATION
  • EMERGENCY CAB EXITS
  • ENGINE DOORS
  • ER BOOM SYSTEM PRECAUTIONS
  • EXHAUST FUMES
  • FIRE PREVENTION
  • FLUID INJECTION INJURY
  • FLUID LEAKS
  • GREASE INJECTION INJURY
  • HARVESTING ATTACHMENT – GENERAL SAFETY
  • HAZARD ZONE
  • HYDRAULIC PRESSURE HAZARD
  • LIGHTNING SAFETY AWARENESS
  • LOOSE CLOTHING HAZARD
  • MACHINE STABILITY AND TRACTION
  • NOISE LEVEL INSIDE CAB
  • PARKING THE MACHINE
  • PROTECTIVE CLOTHING
  • SAFETY INTERLOCK SWITCHES ON CAB DOORS
  • SAFETY LABELS
  • SAFETY PRECAUTIONS, GENERAL
  • SAFETY PRECAUTIONS, OPERATING
  • SAFETY PRECAUTIONS, SERVICING
  • SAFETY SYMBOLS
  • SIGNAL WORDS
  • VIBRATION LEVELS INSIDE CAB
  • WELDING, PRIOR TO
  • WORKING WITH OIL
• SECTION 2 - CONTROLS & OPERATION
  • AMEREX FIRE SUPPRESSION SYSTEM (OPTIONAL)
  • AM/FM STEREO CD
  • ANTI-STALL - SWITCH WITH LIGHT
  • AUTO IDLE - LIGHT
  • AUXILIARY POWER OUTLET
  • BATTERY BOOSTER JUMPER PLUG
  • BATTERY DISCONNECT SWITCH
  • BOOM CONTROLS
  • CARE OF THE MACHINE 
  • CASE DRAIN STRAINERS
  • CIGARETTE LIGHTER
  • CLEANING A/C CONDENSER, OIL COOLER, RADIATOR AND CHARGE AIR COOLER
  • CLEANING INSTRUCTIONS
  • COMPUTER CONTROL SYSTEM (IQAN MDM DISPLAY)
  • DISPLAY MODULE
  • EMERGENCY EXITS
  • ENGINE AIR CLEANER
  • ENGINE ANTI-STALL - SWITCH WITH LIGHT
  • ENGINE DOOR, POWER - SWITCH 
  • ENGINE HOT WATER SHUT OFF VALVES 
  • ENGINE, RESTARTING AFTER ENGINE RUN OUT OF FUEL
  • ENGINE, STOPPING
  • ER BOOM SYSTEM, SPECIAL OPERATING INSTRUCTIONS 
  • FILTER, FRESH AIR - A/C UNIT
  • FILTER, RE-CIRCULATING AIR - A/C UNIT
  • FILTERS
  • FIRE SUPPRESSION SYSTEM (OPTIONAL)
  • FOOT PEDALS, TRACK DRIVE
  • FUEL HEATER SWITCH
  • FUEL TANK
  • FUEL TANKS
  • FUSES AND RELAYS
  • HAND FILL PUMP, HYDRAULIC OIL
  • HORN, SAFETY ALERT - SWITCH
  • HOT WATER SHUT OFF VALVES (ENGINE)
  • HYDRAULIC OIL TANK
  • IGNITION KEY SWITCH
  • INSTRUCTIONS, VEHICLE MOVING
  • INSTRUMENT PANEL
  • INTERIOR LIGHTS
  • JOYSTICKS, LEFT AND RIGHT HAND
  • KEY SWITCH
  • LEVELLING CONTROLS, JOYSTICKS
  • LEVELLING ELECTRONIC ADJUSTMENT PROCEDURE
  • LIGHTS, INTERIOR
  • LIGHTS, SERVICE
  • LOAD SENSING, OPERATING TIPS
  • MACHINE PREPARATION SYSTEM TEST AND WARM-UP
  • MASTER ALARM
  • MOVING, INSTRUCTIONS
  • OPERATING MACHINE
  • PRE-START CHECKS
  • OPERATING TIPS WITH LOAD SENSING
  • OPERATOR’S SEAT
  • PICTOGRAM DESCRIPTIONS
  • PILOT SYSTEM INTERLOCK SWITCH (FRONT DOOR)
  • PILOT SYSTEM “OFF “- PUSHBUTTON SWITCH
  • PILOT SYSTEM RESET - PUSHBUTTON SWITCH
  • POWER ENGINE DOOR - SWITCH
  • SAW - SWITCH
  • SERVICE ACCESS DOORS
  • SERVICE LIGHTS
  • STEREO AM/FM RADIO/CD 
  • SWING BRAKE - SWITCH WITH LIGHT
  • SWING CONTROL, JOYSTICK
  • SYSTEM FUSES AND RELAYS 
  • TELESCOPIC BOOM ELECTRONIC ADJUSTMENT PROCEDURE ADJUSTABLE FUNCTIONS CHART 
  • TELESCOPIC BOOM & PUMP 2 ELECTRONIC ADJUSTMENT PR
  • THROTTLE SWITCH 
  • TRACK DRIVE, FOOT PEDALS
  • TRACK, LOW/DRIVE - SWITCH WITH LIGHT
  • TRAVELLING (BOOM RAISED)
  • TRAVEL SPEED CONTROL LEVER
  • VEHICLE MOVING INSTRUCTIONS
  • WARM-UP MODE 
  • WARNING LIGHTS
  • WORK LIGHTS SWITCH
• SECTION 3 - LUBRICATION & MAINTENANCE
  • AIR CONDITIONING, CHECKING THE SYSTEM
  • AIR INTAKE MAINTENANCE
  • APPROVED HYDRAULIC OILS
  • CASE DRAIN STRAINERS
  • EMERGENCY EXITS, CHECK MONTHLY
  • ENGINE AIR CLEANER
  • ENGINE AIR CLEANER MAINTENANCE 
  • ER BOOM SYSTEM
  • FILTER AND LUBRICATION SCHEDULE
  • FILTERS
  • FUEL TANK
  • HYDRAULIC OILS, APPROVED
  • HYDRAULIC TANK PRESSURIZATION INSTRUCTIONS
  • LUBRICATION POINTS DIAGRAM, LEVELLER
  • LUBRICATION SCHEDULE 
  • NEW MACHINE MAINTENANCE 
  • OIL SAMPLE COLLECTION PROCEDURES
  • OIL SAMPLING PROGRAM
  • PRESSURE AND SPEED SETTINGS
  • PRESSURE SETTING PROCEDURESSERVICE MANUAL
  • PREVENTIVE MAINTENANCE SCHEDULE
  • SCHEDULED MAINTENANCE
  • SWING DRIVE LUBRICATION
  • TORQUE CHART, GENERAL
  • TORQUE, FLUID CONNECTIONS
  • TRACK OPERATION AND WEAR PREVENTION