Terex T300-1 Cranes Operators Manual PDF

Terex Cranes provides the operation and maintenance manuals for construction and industrial equipment. This manual was created by specialists in accordance with all technical standards and is an assistant in the repair and operation of Terex model T300-1 cranes.

Models:
T300-1

CONTENTS:

• SAFETY
  • Introduction
  • Symbols
  • Handling Personnel
  • Training and Knowledge
  • Operator’s Responsibilities
  • Signal Person’s Responsibility
  • Responsibilities of All Crew Members
  • Management Responsibility
  • Planning the Job
  • Operator’s Safety Check
  • Operator Aids Check
  • Operation Overload Protection
  • Operation Setup
  • Power Line Safety
  • Slip and Fall Prevention
  • Travel
• CONTROLS AND INSTRUMENT
  • Universal Symbol Identification
  • Carrier Controls & Instruments
  • Carrier Control And Instrument Key
  • Carrier Controls & Instruments
  • Upper Controls & Instruments
  • Upper Controls & Instruments Key
  • Upper Controls & Instruments
• OPERATING INSTRUCTIONS
  • Seat Belts
  • Pre-Start Inspection
  • Starting The Engine
  • Operating The Engine
  • Cold Weather Starting
  • Jump-Starting And Engine Booster Cable Instructions
  • Vehicular Operation
  • Travelling Around The Job Site
  • Making A Typical Lift
  • Crane Hand Signals
  • Hoist Line Reeving
  • Wire Rope Specifications
  • Transporting The Crane
  • Side Stow Jib
  • Unusual Operating Conditions
  • Load Rating Chart Interpretation
  • Removable Counterweight
  • Air Ride Suspension
  • Dual Mode Boom
  • Remote Carrier Operation
• PERIODIC MAINTENANCE AND LUBRICATION
  • Lubrication Chart
  • Introduction
  • Special Break-In Requirements For New Cranes
  • Machine Maintenance Check Lists
  • Wire Rope Inspection Record
  • Hydraulic Oil Requirements
  • Koehring Spec 805 Data
  • Grade Selection Chart
  • Premium Grade Anti-Wear Hydraulic Oils
  • Cable Lubrication Methods
  • Turntable & Swing Pinion
  • Power Steering
  • Drive Shafts
  • Brakes
  • Air Dryer
  • Slider Pads
  • Boom Lubrication
• TROUBLESHOOTING
  • General Procedure
  • Hydraulic - General
  • Operator Controls
  • Power Steering
  • Front Axle
  • Steering Circuit
  • Rear Axle
  • Alternator
  • Starter
  • Engine Clutch
  • Brakes
  • Parking Brakes
  • Air Pressure
  • Swing Circuit
  • Boom Hoist Circuit
  • Boom Telescope Circuit
  • Winch Circuit
  • Outrigger Circuit
  • Pumps
  • Control Valves
  • Relief Valves
  • Fluid Motor
  • Cylinders
  • Cylinder Leakage
  • Excessive Heating Of Oil In System
  • Electrical Controls
  • Propane Heater
  • Maintenance-Free Battery Testing
  • Anti Two Block System
• SERVICE AND ADJUSTMENTS
  • GENERAL SERVICE INFORMATION
  • WELDING INSTRUCTIONS
  • WELDING & CUTTING ON PAINTED SURFACES
  • OUTRIGGERS
  • REAR SUSPENSION
  • FRONT AXLE
  • REAR AXLE
  • WHEEL AND RIM MOUNTING
  • TIRES
  • ENGINE RADIATOR MAINTENANCE
  • ENGINE CLUTCH ADJUSTMENT
  • SHIFT CONTROL ADJUSTMENT
  • ENGINE MAINTENANCE
  • TRANSMISSION
  • PROPELLER SHAFT & UNIVERSAL JOINTS
  • AIR SYSTEM MAINTENANCE
  • STEERING AND POWER STEERING
  • SWING BEARING BOLTING PROCEDURE
  • TORQUE WRENCH EXTENSIONS
  • SWING REDUCER
  • HYDRAULIC SYSTEM MAINTENANCE
  • PUMPS
  • VALVE ADJUSTMENTS
  • ROTARY MANIFOLD
  • CONTROL LINKAGE ADJUSTMENTS
  • ANTI-TWO BLOCK SYSTEM
  • HEATER
  • ELECTRICAL SYSTEM BATTERY CHECK
  • ELECTRICAL SYSTEM COLLECTOR RING
  • ELECTRICAL SYSTEM VOLTMETER DIAGNOSIS
  • HYDRAULIC CYLINDERS
  • HYDRAULIC CYLINDER MAINTENANCE
  • WIRE ROPE AND REEVING
  • SPOOLING WIRE ROPE ON DRUMS
  • CABLE SOCKETS
  • BOOM CHAIN ADJUSTMENT
  • BOOM CENTERING
  • SETTING BOOM PROXIMITY SENSORS
• MACHINE STORAGE
  • SHORT TERM STORAGE
  • LONG TERM STORAGE
  • ENGINE STORAGE
  • RESTORING ENGINE TO SERVICE
  • TRANSMISSION STORAGE
  • RESTORING TRANSMISSION TO SERVICE
  • RESTORATION TO SERVICE
  • CHROME CYLINDER ROD STORAGE
  • . GENERAL INFORMATION & SPECIFICATIONS
  • CONVERSION TABLES
  • AVERAGE WEIGHT OF MATERIALS
  • SUGGESTED TORQUE RATINGS
  • MACHINE SPECIFICATIONS
• WIRE ROPE USERS MANUAL
  • Wire rope users manual
• WORK PLATFORMS

The objective of the manual is to prevent accidents, reduce downtime and keep the equipment working efficiently. This guide help beginners and experienced professionals in the use and maintenance of this equipment.

Features of the Manual
Format: PDF
Language: English
Pages: 321
Compatible with all versions of Windows, Mac, Linux, iPhone, iPad, and Android
Terex equipment is designed and manufactured to perform heavy-duty work. For this reason, it is essential that the owner and user perform periodic inspection of this equipment. Accordingly, with regular maintenance - your crane will serve you for a long time and quality work.  In this manual, you will find technical information, recommendation, schematics, pictures, and many other data, which help to in this.

FAQs
How do I download the manual?
Immediately after payment, we send you the online file by email to your email address within 1-10 minutes of your purchase. So please make sure your email address is correct. Please check your spam/junk folder if you don't see it in your inbox.

Is the manual printable?
You can easily print the desired text or image that will help your work.

Still have questions?
Feel free to contact us if you have any questions, or problems.