Perkins 4016-E61TRS Engine OEM Application, Installation And Commissioning Handbook EMS System PDF

This manual provides detailed service information, special instructions, troubleshoot and other additional service information for Perkins Engine 4016-E61TRS.
This instruction allows you to identify and resolve problems and inaccuracies.
Manual is presented in PDF format, includes 38 pages and works after installing Adobe PDF Reader, which allows you to find the necessary information, as well as to print out individual pages or the entire text as a whole.

Models covered:
4016-E61TRS - 16 cylinder, turbocharged, gas engines

Contents:

• 1 Description of EMS Facilities
  • Introduction
  • Engine Management System Block Diagram
• 2 Outline of Facilities
  • Start/Stop Controls
  • Air/Fuel Ratio Control
  • Speed Governing
  • Ignition System
  • Engine Protection
  • Remote Indication and Inputs
  • Speed Setting
  • Remote Monitoring
  • Engine Management System Options Diagram
• 3 OEM Wiring
  • OEM Connector
  • Cable Sizes
  • Wiring Layout
  • Battery Cables
  • Customer Communications Module
  • Battery Charger
  • OEM Connector Diagram
• 4 Description of OEM Connections and Installation Requirements
  • Mode Control Switch
  • Timing Select Switch
  • Fault Stop Contact
  • Idle/Rated Switch
  • On/Off Grid
  • Emergency Stop
  • 4-20mA Optional Input
  • Speed Trim Potentiometer or Remote Speed Control Input
  • Grounding Requirements
  • Requirements for Automatic Synchronsing and Load Sharing Systems
  • Manual Pre-Lub
  • Gas Shutoff Valve Relay
  • Pre-Lub Pump Relay
  • Run Relay
  • Crank Terminate
  • Engine Shutdown
  • Engine Alarm
  • Low Gas Pressure
  • Low Water Level
  • Low Oil Level
  • Battery Supply
• 5 Protection System
  • Protection Settings
• 6 Installation Requirements
  • Welding
  • Electrostatic spraying
  • Exhaust System
  • Gas Supply
  • General
  • Cooling System
  • Maintenance
• 7 Commissioning Procedure
  • Pre-Start Checks
  • Standard Parameter Settings
  • Initial Starting
  • Typical Readings with Engine at Full Load
  • Final Adjustments
  • Timing Control
  • Air Fuel Ratio Control
  • Speed Control
  • Start/Stop Control
  • Appendix A - Engine Blco kWiring Diagram
  • Appendix B - Oxygen Sensor Calibration
  • Appendix C - Gas Engine Start Sequence
  • Appendix D - Gas Engine Stop Sequence