Hitachi EX200-2 Excavator Technical Workshop Manual PDF

This manual contains guidance on repair, technical instructions, workshop information that help to provide timely and quality care in the installation, dismantling, operation, calibration, and repair for excavators Hitachi EX200-2.
This manual includes detailed schematics and diagrams, with which you can visually view of a piece of equipment.
To work with this manual you need to install the application Adobe PDF Reader. This manual is in PDF format.

Contents of Technical Manual (Operational Principle):

• SECTION 1 - SPECIFICATION
  • Group 1 - General Information
  • Group 2 - Dimensions and Weights
  • Group 3 - Fuels and Lubricants
  • Group 4 - Interchangeability
• SECTION 2 - UPPERSTRUCTURE
  • Group 1 - Layout
  • Group 2 - Tanks
  • Group 3 - Pump Device
  • Group 4 - Swing Device
  • Group 5 - Pipings
  • Group 6 - Control Valve
  • Group 7 - Pilot Valve
  • Group 8 - Lock Valve
• SECTION 3 - UNDERCARRIAGE
  • Group 1 - Component Location
  • Group 2 - Swing Bearing
  • Group 3 - Center Joint
  • Group 4 - Travel Device
  • Group 5 - Adjuster
• SECTION 4 - ELECTRICAL SYSTEM
  • Group 1 - Component Location
  • Group 2 - Engine Control System
  • Group 3 - Monitor
  • Group 4 - Circuit Operation
  • Group 5 - Inspection and Maintenance
• SECTION 5 - HYDRAULIC SYSTEM
  • Group 1 - General
  • Group 2 - Control System
  • Group 3 - Main Hydraulic Circuit
• SECTION 6 - OPERATIONAL PERFORMANCE TEST
  • Group 0 - Standard
  • Group 1 - Introduction
  • Group 2 - Enigne Test
  • Group 3 - Excavator Test
  • Group 4 - Hydraulic Component Test
  • Group 5 - Basic Performance Check
• SECTION 7 - TROUBLESHOOTING
  • Group 1 - Diagnosing Procedure
  • Group 2 - Connector
  • Group 3 - Troubleshooting A
  • Group 4 - Troubleshooting B
  • Group 5 - Troubleshooting C
  • Group 6 - Harness Check

Contents of Workshop Manual:

• SECTION 1 - SPECIFICATIONS
  • Group 1 - Tightening Torque
  • Group 2 - Painting Standard
• SECTION 2 - UPPERSTRUCTURE
  • Group 1 - Cab
  • Group 2 - Counter Weight
  • Group 3 - Main Frame
  • Group 4 - Pump Device
  • Group 5 - Control Valve
  • Group 6 - Swing Device
  • Group 7 - Pilot Valve
  • Group 8 - Shut-Off Valve
  • Group 9 - Shockless Valve
  • Group 10 - Accumulator
  • Group 11 - Solenoid Valve
  • Group 12 - Shuttle Valve
  • Group 13 - Swing Dampener Valve
• SECTION 3 - UNDERCARRIAGE
  • Group 1 - Swing Bearing
  • Group 2 - Travel Device
  • Group 3 - Center Joint
  • Group 4 - Track Adjuster
  • Group 5 - Front Idler
  • Group 6 - Upper and Lower Roller
  • Group 7 - Track Link