Fiat Kobelco SL35B, SL40B Compact Loader With Accessories Workshop Manual PDF

Workshop manual contains detailed technical service information, repair and maintenance instructions, fitting instructions, step by step instructions, specifications, charts for Fiat Kobelco Compact Loaders SL35B, SL40B.
This workshop manual provides technical information needed to properly service and maintain models SL35B and SL45B skid steers.
Workshop manual comes in PDF format and includes 680 pages, which are printable. We recommend using Adobe PDF Reader, to be sure all images/graphics will display correctly.

Models covered:
SL35B,
SL40B.

CONTENTS:

• SECTION 00 – GENERAL INFORMATION
  • Introduction
  • About Improvements
  • Company Policy
  • Parts and Accessories
  • Model Codes
  • Precautionary Statements
  • Safety Precaution Information
  • General Safety Information
  • Machine Model and Serial Number Location
  • Engine Model and Serial Number Location
  • Hardware Torque Specifications
  • Installation of Adjustable Fittings in Straight Thread O Ring Bosses
  • Standard Torque Data for Hydraulic Tubes and Fittings
  • Pipe Thread Fitting Torque
  • Lubricants and Coolants
  • Sealants
  • Properly Support a Raised Machine
  • Properly Support Boom on Boom Lock Pins
  • Raising Boom Without Hydraulic Oil Flow
  • Raising Boom Without Battery Voltage (12V)
  • Reattaching Cylinders After Repair with Boom Resting on Boom Lock Pins
  • Major Unit Overhaul
  • Cab and Boom Tilt Procedure
  • Craning the Skid Steer
  • Special Tools
  • Specifications
  • Dimensions
• SECTION 10 – ENGINE
  • General Engine Information
  • Engine Removal
  • Valve Seat
  • Cylinder Block
  • Piston and Piston Rings
  • Bearing Holder
  • Crankshaft
  • Flywheel and Ring Gear
  • Camshaft Assembly
  • Camshaft Gear and Bearing Assembly
  • Oil Pump
  • Oil Filter
  • Water Pump Assembly and Thermostat Housing
  • Thermostat
  • Governor
  • Engine Reassembly Sequence
  • Reinstallation of Engine into Skid Steer Frame
  • Fuel Injection Timing
• SECTION 29 – HYDROSTATIC TRANSMISSION
  • General Information
  • Troubleshooting
  • Hydrostatic Pump Removal
  • Hydrostatic Pump Disassembly
  • Hydrostatic Motor Removal
  • Hydrostatic Motor Disassembly
  • Charge Check Valve Removal and Replacement
  • Steering System
  • Left Control Handle With No Boom Control
  • Right Control Handle With Auxiliary or Bucket Control
  • Drive Control Adjustment Procedure
  • Neutral Adjustment
• SECTION 33 – BRAKES AND CONTROLS
  • General Information
  • Parking Brake
• SECTION 35 – HYDRAULIC SYSTEM
  • General Information
  • Main System Pressure Tests
  • Control Valve Removal
  • Control Valve Disassembly and Inspection
  • Hydraulic Pump Removal
  • Hydraulic Pump Disassembly
  • Boom Cylinder Removal
  • Boom Cylinder Disassembly
  • Bucket Cylinder Removal
  • Bucket Cylinder Disassembly
  • Pedal Removal (With Boom and Bucket Pedal Controls)
  • Pedal Removal (With Boom and Bucket Hand Controls)
  • Hydraulic Cooling, Filter, Reservoir System
  • Filter System
  • Filter Removal
  • Base Removal
  • Oil Cooler Removal
  • Oil Reservoir
  • Oil Reservoir Removal
• SECTION 37 – TOWING HOOKS AND BALLASTING
  • Rear Counterweights
  • Rear Counterweight Support Removal
• SECTION 39 – FRAMES
  • General Information
  • Cab and ROPS
  • Cab and ROPS Removal
  • Cab and ROPS Reinstallation
• SECTION 44 – AXLES AND WHEELS
  • General Information
  • Axles
  • Axle Housing Assembly Removal
  • Axle Disassembly
  • Final Drive Removal
  • Tyres/Wheels
• SECTION 50 – CAB CLIMATE CONTROL
  • Heater/Defroster (Cab)
• SECTION 55 – ELECTRICAL SYSTEM
  • General Electrical Information
  • Advanced Warning System
  • Removal, Installation, and Wiring of Electrical Components
  • Battery Removal
  • EIC (Electronic Instrument Cluster) Board Removal
  • Ignition (Key) Switch Removal
  • Service/Run Switch Removal
  • Seat Switch Removal
  • Road Light and Work Light Switch Removal
  • Preheat Circuit Breaker Removal
  • Start Interlock Relay Removal
  • Alternator Excite Resistor Removal
  • Start Relay Removal
  • Preheat Relay Removal
  • Electric Fuel Pump Removal
  • Fuel Shutoff Solenoid
  • Replacement of Fuel Shutoff Solenoid
  • Air Filter Restriction Indicator Switch Removal
  • Engine Coolant Temperature Sender Removal
  • Engine Oil Pressure Switch Removal
  • Hydrostatic Charge Pressure Switch Removal
  • Hydraulic Oil Filter Restriction Switch Removal
  • Hydraulic Oil Temperature Sender Removal
  • Boom/Bucket Control Valve Spool Lock Solenoids Removal
  • Main Wire Harness Removal
  • Road/Work Lights
  • Alternator (40 Amp Version)
  • Alternator Removal
  • Alternator Disassembly
  • Starter
  • Starter Motor Removal
• SECTION 82 – FRONT LOADER (Boom And Mounting Plate)
  • General Information
  • Boom Lock Pins and Linkage
  • Attachment Mounting Plate
  • Pallet Fork
  • Utility Fork
  • Bucket Cutting Edge (Replacement)
  • Bucket Latch Plate Installation Procedure
  • Dirt Tooth Kit Installation
  • Boom Lock Pin/Linkage Removal
  • Front Boom Mounting Plate Pivot Hub Replacement
  • Attachment Mounting Plate Removal
  • Latch Lever and Pin Removal/Repair
• SECTION 88 – ACCESSORIES
  • General Information
  • Arm Pads For Cab Side Panels
  • Armrests for Deluxe Seat
  • Forearm Rests
  • Back-up Alarm
  • Block Heater (Engine)
  • Electric Power Supply (12 Volt, 15 Amp)
  • Exhaust (Engine)
  • Aspirator Precleaner Muffler
  • Horn
  • Shoulder Belt (Seat)
  • Slow-moving Vehicle (SMV) Sign Kit
  • Warning Light (Rotary Beacon)
  • Warning Lights (Four-way Flashers/Turn Signal/Horn)
• SECTION 90 – PLATFORMS, CAB, BODYWORK, AND DECALS
  • General Information
  • Seat and Seat Pan Support
  • Seat Removal
  • Seat Pan Support Removal
  • Safety Decals